The Non-Linear Forming Limit Diagram

Welcome to 2009! It’s a new year so let’s talk about something that might be new to even those who have seen and used simulation many times previously.

The Forming Limit Diagram (FLD) is the fundamental tool which is used to judge whether a formed sheet metal part is predicted to fail or pass, when analyzing simulation results. The “standard” FLD assumes a linear strain path, however, strain paths are not always linear in reality.

Non-linear strain paths usually begin occurring in secondary and subsequent forming operations, especially when the material is formed in the reverse or opposite direction. Therefore, if only a linear FLD is considered in a multi stage sheet metal forming simulation, it is possible that a non-linear failure mode may be overlooked.

Therefore, non-linear FLD analysis is required in many cases before a sheet metal forming simulation can be given a “pass”. StampingSimulation.com uses AutoForm Incremental and non-linear FLD analysis is an integral part of this software.

[Left: Standard Linear FLD. Right: Non-linear FLD showing additional failure mode]

If you are concerned that your simulation provider is not capturing non-linear failures, StampingSimulation can show you how to ensure this potential failure mode is not overlooked.

Get started by .(JavaScript must be enabled to view this email address) OR by sending us your 3D product or tooling data. Non-linear analysis (when required) is always part of any SimulateLite or SimulateComplete simulation job.

Information Kit

Attend a Webinar

Sample Simulation

Start a Job Now

 

 

EasyStamping.com © 2017
Terms & Conditions | Privacy Policy